Removed nested tab

intro/blinkLED.rst

@@ -57,42 +57,41 @@ take the ``ssh (Linux/Mac)`` tab.  Finally take the
         line within VS Code, or run them by clicking the
         ``RUN Code`` button.
 
-        .. tabs::
 
-            .. group-tab:: Running via the command line
+        Running via the command line
 
-                Open a terminal window in VS Code by dropping down the 
-                ``Terminal`` menu and selecting ``New Terminal`` (or entering 
-                ``Ctrl+Shift+```).  The terminal window appears at the 
-                bottom of the screen as shown below.
+            Open a terminal window in VS Code by dropping down the 
+            ``Terminal`` menu and selecting ``New Terminal`` (or entering 
+            ``Ctrl+Shift+```).  The terminal window appears at the 
+            bottom of the screen as shown below.
 
-                .. figure:: figures/vscode3.png
+            .. figure:: figures/vscode3.png
 
-                You can now enter commands and see them run as shown below.
+            You can now enter commands and see them run as shown below.
 
-                .. figure:: figures/vscode4.png
+            .. figure:: figures/vscode4.png
 
-            .. group-tab:: Running via the ``RUN`` button
+        Running via the ``RUN`` button
 
-                Use the file navigator on the left to navigate to 
-                ``examples/BeagleBone/Black/blinkInternalLED.sh`` 
-                and you will see:
+            Use the file navigator on the left to navigate to 
+            ``examples/BeagleBone/Black/blinkInternalLED.sh`` 
+            and you will see:
 
-                .. figure:: figures/vscode2.png
+            .. figure:: figures/vscode2.png
 
-                This code blinks one of the USR LEDs built into the board. 
-                Click on the ``RUN Code`` triangle on the upper right of 
-                the screen to run the code.  (You could also enter ``Ctrl+Alt+N``) 
-                The USR3 LED should now be blinking.  
+            This code blinks one of the USR LEDs built into the board. 
+            Click on the ``RUN Code`` triangle on the upper right of 
+            the screen to run the code.  (You could also enter ``Ctrl+Alt+N``) 
+            The USR3 LED should now be blinking.  
 
-                Click on the ``Stop Code Run`` (``Ctrl+Alt+M``) square to the right of the 
-                ``Run Code`` button.
+            Click on the ``Stop Code Run`` (``Ctrl+Alt+M``) square to the right of the 
+            ``Run Code`` button.
 
-                Time to play!  Try changing the LED number (on line 10) from 
-                3 to something else.  Click the ``Run Code`` button (no 
-                need to save the file, autosave is on by default).
+            Time to play!  Try changing the LED number (on line 10) from 
+            3 to something else.  Click the ``Run Code`` button (no 
+            need to save the file, autosave is on by default).
 
-                Try running ``seqLEDs.py``.
+            Try running ``seqLEDs.py``.
 
     .. group-tab:: ssh (Linux/Mac)